Genesys Logic

USB2.0 Hub Controller

Compliant to USB specification Revision 2.0
− Support 4/3/2 downstream ports by I/O pin configuration
− Upstream port supports both high-speed (HS) and full-speed (FS) traffic
− Downstream ports support HS, FS, and low-speed (LS) traffic
− 1 control pipe (endpoint 0, 64-byte data payload) and 1 interrupt pipe (endpoint 1, 1-byte data payload)
− Backward compatible to USB specification Revision 1.1
On-chip 8-bit micro-processor
− RISC-like architecture
− USB optimized instruction set
− Performance: 6 MIPS @ 12MHz
− With 64-byte RAM and 2K mask ROM
− Support customized PID, VID by reading external EEPROM
− Support downstream port configuration by reading external EEPROM
Single Transaction Translator (STT)
− Single TT shares the same TT control logics for all downstream port devices
    This is the most cost effective solution for TT
    Multiple TT provides individual TT control logics for  each downstream port
    This is a performance better choice for USB 2.0 hub. Please refer to GL852 datasheet for more
    detailed information
Integrate USB 2.0 transceiver
Each downstream port supports two-color status indicator, with automatic and manual modes compliant to USB specification Revision 2.0 (Not supported on SSOP 28 package)
Built-in upstream 1.5K pull-up and downstream 15K pull-down
Embed serial resister for USB signals
Support both individual and gang modes of power management and over-current detection for downstream ports (Individual mode is not supported on SSOP 28 package)
Power enable pin supports both low/high-enabled power switches
Conform to bus power requirements
Automatic switching between self-powered and bus-powered modes
Support compound-device (non-removable in downstream ports) by I/O pin configuration
Configurable non-removable device support
Built-in PLL supports external 12 MHz crystal / Oscillator clock input
Optional 27/48 MHz Oscillator clock input (Not available on QFN 28 / SSOP 28 package)
Built-in 5V to 3.3V regulator
Low power consumption
Improve output drivers with slew-rate control for EMI reduction
Internal power-fail detection for ESD recovery
Available in 48-pin LQFP and 28-pin SSOP package (Full Function only available in 48-pin)
Number of Downstream port can be configured by GPIO without external EEPROM
Applications:- Stand-alone USB hub
− Stand-alone USB hub
− PC motherboard USB hub, docking of notebook
− Gaming console
− LCD monitor hub
− Any compound device to support USB hub function